Accessing the Off-Campus VPN

Connecting to GlobalProtect

Using openconnect

Open a terminal, and type:

sudo openconnect --protocol=gp gp.rose-hulman.edu

When the following appears:

RHIT EMAIL ADDRESS:

type in your Rose-Hulman email address and press ENTER.

Right after this, type in your network password, then press ENTER.

Now, try going to mirror.csse.rose-hulman.edu in a web browser. If you see something there, you are connected. If you get a server error or something similar, you are not.

Alternatively, if you prefer the command line, type ping mirror.csse.rose-hulman.edu and see if there is a response from the server - if you are connected, it should say PING from (ip address): 20ms or similar.

To disconnect, press the Control and C keys at the same time in the terminal. Wait until you see your normal shell prompt such as: username@hostname:directory$ (source: https://www.howtogeek.com/307701/how-to-customize-and-colorize-your-bash-prompt/).

Using the GlobalProtect GUI

Look for "Setting up the client on Linux" header on this page: https://rose-hulman.microsoftcrmportals.com/knowledgebase/article/KA-01278/en-us

Historical information on Juniper/PulseSecure

Adapted from EIT's documentation: https://servicedesk.rose-hulman.edu/knowledgebase/article/KA-01093/en-us

Open a terminal, and type:

sudo openconnect --juniper sslvpn.rose-hulman.edu

When the following appears:

frmLogin
realm [Users|DeltaV|Vendors]:

type in Users and press ENTER.

Then, when this appears:

frmLogin
username:

Type in your Rose-Hulman network username, press ENTER.

Right after this, type in your network password, then press ENTER.

Now, when ESP session established with server appears in the terminal, you are connected.

To disconnect, press the Control and C keys at the same time in the terminal. Wait until you see your normal shell prompt such as: username@hostname:directory$ (source: https://www.howtogeek.com/307701/how-to-customize-and-colorize-your-bash-prompt/).